Description
Similar to Original Equipment handlebar on the '14 CVO™ Road King® model, this beefy 1-1/4" handlebar places the rider in a laid-back riding posture.
- Provides 2” of additional pullback, and a 3” lower hand position than the Original Equipment Road King® bar
- Allows you to tuck the wires inside the bar for a clean, custom look
- 1.25" in diameter
Features
-
Material Content
Steel -
Material Diameter
1.25 Inch -
Tip-to-Tip
31.56 Inch -
Base Width
9.0 Inch -
Knurl Center-to-Center
3.25 Inch -
Rise
9.85 Inch -
Pullback
7.54 Inch -
Warranty
1 year limited warranty – Go to www.h-d.com/warranty for full details -
Sold in Unit
Each -
In The Box
Handlebar only -
Sold Separately
Additional installation components
Fitment
Fits '14-later Road King® models (except FLHRXS). All models require separate purchase of additional components for installation.
Bike not listed?
Select your year and model to see all the parts that fit your bike.
More Info
Note
Installation of some handlebars and risers may require a change in clutch and/or throttle cable and brake lines for some models. Handlebar height is regulated in many locations. Check local laws to ensure your motorcycle meets applicable regulations.
Reviews
Road King Fat Handlebar is rated
out of
5 by
1.
Rated 5 out of
5
by
VRay from
Look and fit great
Would have been really helpful if ALL needed parts are suggested when ordering the handlebars. Had to separately order risers and extended cables. Slowed down this project. Overall took about 3.5 hrs to install
Date published: 2016-09-06
Q & A
road king fat handlbar
one more question.
any special considerations involved with the electronic throttle, swapping factory handlebars to the fat road king ones?
Hi AndyG,
The I-sheet for installing the Road King Fat Handlebar is available through the H-D Online Store under More Info. For electrical information, please see your local H-D dealership for assistance.
Thanks!
Date published: 2016-11-16
cable length
is there a part number for the front brake cable and clutch cable
when installing the road king fat handlebars, on a 15 roadking?
Hey AndyG,
Cables and lines are posted below.
Thanks!
Rockstar883
Date published: 2016-10-12
Do these bars require extending wires or longer brake line?
Hello TechRon,
You will be required to purchase the wire extension kit PN 69200034, riser kit PN 55900067, a clutch cable and upper brake line.
Thank you!
Date published: 2018-01-13
Recently Viewed
Loading...
Please Hold Your Iron Horses
Please Hold Your Iron Horses